Kone преобразователи ошибки

ПЛК, ЧПУ, одноплатные компьютеры и т.д. / Частотные преобразователи / Ошибки ЧП
Administrator
968
7-06-2019, 20:09
0

Ошибка 0001 (error 0001) - driver long time after a period of the position signal 30/B30 running time does not change;
Ошибка 0004 (error 0004) - three consecutive synchronous operation failed. Three consecutive synchronous operation of the system are not receiving proper leveling signal slowdown after three failed to stop at the end of the station;
Ошибка 0007 (error 0007) - Area 308,030 switch stuck after the start time is not detected falling edge 30/B30 signal. Door zone has been effective operation of the switch to the destination 30/B30;
Ошибка 0008 (error 0008) - NVRAM damaged or capacity is not enough when the power transmission capacity is not enough to detect NVRAM;
Ошибка 0014 (error 0014) - Area check the circuit did not release any of two consecutive .486.443.1.443:2 without (ACO / ACL) run to the destination floor;
Ошибка 0015 (error 0015) - Area check circuit does not pull any one .486.443.1.443:2 consecutive times without (ACO / ACL) run to the destination floor;
Ошибка 0021 (error 0021) - safety circuit fails. Safety circuit input a no voltage is immediately stopped. Safety circuit switched;
Ошибка 0022 (error 0022) - Hall door barrier. 3 no-voltage input safety circuit stop immediately. Hall door turns;
Ошибка 0023 (error 0023) - door lock will not work. Safety circuit voltage input 2 no stop immediately;
Ошибка 0025 (error 0025) - start of system failure when the elevator did not stop the main contactor release does not start;
Ошибка 0026 (error 0026) - drive system failure. Driven system detects a fault (v3FCK not light ) does not start;

Обсудить на форуме